overclockSPD

6.4easy start · #17 of 30
in PC Overclocking Software

Free to practise onnot on record
Free trialnot on record
Well documentedyes
Runs where you worknot on record

Runs on Linux.

Visit site Alternatives

overclockSPD is ranked #17 of 30 in PC overclocking software on The Geeks Club. It runs on Linux.

Compared on PC overclocking software

Free plan: Yes
CPU tuning: No
Memory tuning: Yes
Motherboard controls: No
Automatic overclocking: No
Supported platforms: linux

Best overclockSPD alternatives

See all 20

OCCT 0 of 4 in the starter kit Lesson 17.2 Universal x86 Tuning Utility 0 of 4 in the starter kit Lesson 27.2 MemTest86+ 0 of 4 in the starter kit Lesson 37.1 RyzenAdj 0 of 4 in the starter kit Lesson 47.1 Intel VTune Profiler 0 of 4 in the starter kit Lesson 57.0 Quick CPU 0 of 4 in the starter kit Lesson 67.0

The record

Purpose: overclockSPD provides scripts for Linux users to read and write RAM SPD data and modify timings, voltages, and configuration.
SPD reading and writing: The project includes shell and Python scripts for reading and writing SPD data, with commands that operate on one target at a time.
EMP to XMP conversion: The project can convert .emp files created by Thaiphoon Burner into .xmp files.
Hardware access: The installation instructions require the i2c_dev, i2c_i801, and eeprom modules and the i2c-tools package.
Output location: Read results are saved in the current working directory, which must be writable by the user.
Data safety: The project warns that writing to non-DIMM locations through SMBus can damage or brick hardware.
Warranty: The author provides the software as is and disclaims warranties, including claims about safety, suitability, and absence of viruses.
User responsibility: The disclaimer places responsibility for compatibility, equipment protection, and data backups on the user.
Troubleshooting: For a device-busy error at address 0x50, the README suggests unloading the at24 module.
Intended audience: The README describes the scripts as tools for Linux users and contrasts them with similar tools that it says run only on Windows.
License: The repository identifies its license as GPL-3.0.
GUI status: The README says a GUI for RAM overclocking will also be included, phrased as planned functionality.
Intended users: The project describes its tools as being for Linux users.
SPD read and write: The scripts read or write one target at a time, selected by bus address and DIMM address.

Where it ranks on The Geeks Club

Best PC Overclocking Software in 2026#17 of 30

Is overclockSPD yours?

Claim it for free: prove the domain, then correct facts, plans and screenshots. An editor reviews every change.

Claim it free Promote overclockSPD

Sources

github.com/baboomerang/overclockSPD· checked 4 Oct 2026